Sitecom WLR-6000 OpenWrt Firmware

CPU: Ralink RT3883
RAM: 64 MB
Flash: 16 MB

The Sitecom WLR-6000 is supported by OpenWrt on the ramips/rt3883 target. 2 firmware images are available from the official OpenWrt 25.12.5 stable release — download one below, or build a custom OpenWrt image for this device with your own package selection.

Specs

Specifications

CPU	Ralink RT3883
CPU cores	1
CPU frequency	500 MHz
RAM	64 MB
Flash	16 MB
1 Gbit Ethernet ports	5
WLAN hardware	Ralink RT3883, Ralink RT5392
Switch	Atheros AR8327

Hardware data from the OpenWrt Table of Hardware; verify against your unit before flashing.

Build matrix

Supported firmware versions

Distribution	Version	Target	Profile
OpenWrt	25.12.5	ramips/rt3883	sitecom_wlr-6000

Downloads

Download images

OpenWrt 25.12.5 · ramips/rt3883

Image	Type	sha256
openwrt-25.12.5-ramips-rt3883-sitecom_wlr-6000-squashfs-sysupgrade.bin Not sure? Pick this if upgrading from OpenWrt.	sysupgrade	65d3bec1625c…
openwrt-25.12.5-ramips-rt3883-sitecom_wlr-6000-squashfs-factory.dlf For first-time flash from stock firmware.	factory	ac57a4d656cd…

Downloads are served by the official OpenWrt mirrors — unchanged upstream stable builds.

Packages & install

Default packages & installation

Default packages

Every image for the Sitecom WLR-6000 ships these packages by default. The customize option below lets you add or remove packages before the image is assembled.

Device packages (2)

kmod-usb-ohci kmod-usb2

Target default packages (29)

apk-mbedtls base-files ca-bundle dnsmasq dropbear firewall4 fstools kmod-gpio-button-hotplug kmod-leds-gpio kmod-nft-offload kmod-rt2800-pci kmod-rt2800-soc libc libgcc libustream-mbedtls logd mtd netifd nftables odhcp6c odhcpd-ipv6only ppp ppp-mod-pppoe swconfig uci uclient-fetch urandom-seed urngd wpad-basic-mbedtls

Installation notes

First install from stock firmware: flash the factoryimage through the vendor firmware's upgrade page or recovery mode.
Already running OpenWrt or ImmortalWrt: flash the sysupgrade image from LuCI (System → Backup / Flash Firmware) or with the sysupgrade command.

Verify your download against the published checksum before flashing:

$ sha256sum openwrt-25.12.5-ramips-rt3883-sitecom_wlr-6000-squashfs-sysupgrade.bin
65d3bec1625c8a10242d6a41b4f8a56e0823945d12d87bea83b86c7bddaeea11  openwrt-25.12.5-ramips-rt3883-sitecom_wlr-6000-squashfs-sysupgrade.bin

Build custom firmware

Need more than the default image for the Sitecom WLR-6000? Pick your packages — LuCI apps, themes, VPN clients — set the basics, and get a ready-to-flash OpenWrt image assembled from official packages in minutes.

Customize firmware for this device

More Sitecom devices

More devices on ramips/rt3883

Upstream

Upstream & source

Images are assembled from packages compiled and published by the upstream OpenWrt and ImmortalWrt projects. The complete corresponding source code is available from those projects under the GPL.